This product is in high demand. A high volume of orders may result in delays due to restocking.Protective face shields keep our essential workers safe. Now you can brand them with custom stickers.
Our branded face shields come with branded stickers that must be applied onto the shield by the client (they do not come pre-applied)
A portion of proceeds from this product goes to the Ohio State University Wexner Medical Center.
These turnaround times have been updated to reflect temporary changes as we adjust to new social distancing protocols in production.
We will print your client’s brand or design on 1.5”H x 13”W vinyl stickers and ship them with your face shield order. You or your client can then easily apply them onto the face shields as shown in the picture.
Peel off the protective film before use. Stretch the elastic around your head so that the foam sits on your forehead. This product is suitable for individual use only. Do not share it with others.
Clean both sides of the shield with soap and warm water after each use. Sanitizer can be applied with a paper towel. Aggressive cleaning agents are not recommended. Store in a safe, clean, and dry area, such as a Ziploc bag. Dispose after 7 days of usage.
Our face shields put safety first. As a result of using specific hospital-approved materials, this type of PET is not 100% clear, but provides good visibility for essential workers. Over 1,000 have been donated so far to North York General Hospital and are being used by front line professionals as hospital grade equipment.
Start selling face shields to these essential workers:
• Health care providers
• Emergency response teams
• Animal health care providers
• Retail, grocery store, and service employees
PET shield meets FDA requirements under 21 CFR 177.1630. EVA filler complies with FDA regulations 21 CFR 177.1350, Paragraphs (a), (c), (d), and (e).
Our face shields come with a protective plastic film to prevent scratches to the shields during packing and shipping. Remove the film before using the product.Removing the Film
Ensure the file matches the product's required dimensions. Ensure that the artwork is created in CMYK 300 dpi with 1/16 inch bleeds on all sides.
Make sure that all images are embedded, and that all the text is outlined.
Export all files into PDF format with bleeds.
File Orientation refers to the orientation of the artwork files submitted. Ensure that they are submitted to back up properly to produce the intended result.